9 articles Stitch Quality

Pattern Shifting on the Quilt

If the pattern seems to be getting off on one or both directions this is most often due to a belt slipping. The machine will move, but the pulley which tracks the movement for the system will not turn making the system think that it did not move momentarily. In rare cases it can be…

Nolting machine won’t start stitching at first or has inconsistent stitching with Butler or PerfectStitch

If your Nolting machine is not stitching a it should and you have already been through the steps to set machine type or motor load ratio, then you might be running into a timing issue with the machine. Nolting has recommended these steps to reset the hook timing on the machine. remove the bobbin and…

Machine is stitching where it is supposed to jump stitch

If your machine is stitching where it should be jump stitching it is likely because you are engaging the needle on your handlebar, and not from the tablet. Since the tablet is what talks between the robotics machine, if you do not tell the tablet that the needle is on then it wont know to…

Why Do I Receive Motor Errors And/Or Skipped Stitches When I Am In Stitching Mode And Not Trace Mode?

The robotics produces Motor Failure or Skipped Stitches Errors when stitching a pattern but not when tracing a pattern. Stitch Regulator Problem If the robotics can trace a pattern (move the needle the to-be-quilted pattern without stitching) without error, then the problem lies with the stitch regulator, not with the robotics system. Monitor the encoders…

Why Does My Robot Stitch The Same Pattern Twice, One On Top Of The Other?

How to correct a pattern that is stitching twice in the same position. Check for pattern duplicates two identical patterns that overlap each other appear on the screen as a single pattern. use Edit > Move to move the pattern around and check for any duplicates. Delete any unwanted duplicates to correct the issue. Update software Ensure…

Why Does My Robot Stitch The Jump Stitch Between Rows?

The stitch controller is not highlighted. Ensure stitch controller is selected When stitching patterns, press the needle and thread icon so that it is highlighted green. With the stitch controller engaged, you should now be able to stitch patterns normally without stitching jumpstitches. (A good way to tell if the stitch controller is engaged is…