3 articles Errors (ps)

PS Errors

Setting Machine Motor Ratio

On the Perfect Stitch system because the pulley on your system has most likely changed, you will need to set the ratio of the pulley.  This is easily done, follow the attached document to set the proper pulley ratio on your machine. The way to know if this needs to be done is: Your needle…

Why am I getting so Many Random Errors When I Try and Boot Up the Machine?

Random display errors on the Display at boot up. Sometimes you can get to the home screen, sometimes not. Do the lights light up properly on the PCB Box? After boot up, the lights on the PCB should have the bottom two lit up, as pictured below. For more about the meaning of the lights,…

Error – Could Not Move To Start: Err: 1023

The robotics has been unable to return the needle to the start point of the pattern.   Remove obstruction Remove whatever is in the way of the machine returning to the start point. This could be Check belts Ensure that your belts are attached properly and have adequate tension. If the belts are on backwards, then the…